My new Muse Proto board will not show up as a bluetooth device.
I followed the (1-Quick and dirty (no soldering)) instuctions on
downloaded the bin-file and the program.
Ran the program and added the bin-file and found the port
The progress took about 5 seconds to go from Idle to Sync, Download and then to Finish. (Not 3 minutes like the instruction indicated).
The command window that pops up shows this
Uploading stub…
Running stub…
Stub running…
FLASH_CRYPT_CNT 0
ABS_DONE_0 False
is stub and send flash finish
I’m no progarmmer so is there an easy way to get tihs to work?